Miele KM2335 Manuel

Naviguer en ligne ou télécharger Manuel pour Plaques chauffantes Miele KM2335. Miele KM2335 hob Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer

Résumé du contenu

Page 1 - Gas hobs

Operating and installation instructionsGas hobsTo avoid the risk of accidents or damage to the appliance it is essentialto read these instructions bef

Page 2

This appliance complies with all relevant local and national safetyrequirements. Improper use of the appliance can, however,present a risk of both per

Page 3

Safety with children~This appliance is not a toy! To prevent the risk of injury, do notallow children to play with it or use the controls. Please supe

Page 4 - Contents

Technical safety~Before installation, check the appliance for visible signs ofdamage. Do not install and use a damaged appliance. It could bedangerous

Page 5

~Never open the outer casing of the appliance. Tampering withelectrical connections or components and mechanical parts ishighly dangerous to the user

Page 6 - Guide to the appliance

~In areas which may be subject to infestation by cockroaches orother vermin, pay particular attention to keeping the appliance andits surroundings in

Page 7

~Do not use the appliance as a resting place for anything else. Thearticle could melt or catch fire if residual heat is still present or if theapplian

Page 8

~Remove splashes of fat and other food debris from the surface assoon as possible. These are a fire hazard.~Replace the pan supports carefully to avoi

Page 9

~If the appliance is installed behind a kitchen furniture door, it mayonly be used with the furniture door open.Only close the door if the appliance i

Page 10 - Correct application

Disposal of the packingmaterialThe packaging is designed to protectthe appliance from damage duringtransportation. The packaging materialsused are sel

Page 11 - Safety with children

Please stick the extra data plate for the appliance suppliedwith this documentation in the space provided in the "Aftersales service, data plate&

Page 12 - Technical safety

G This appliance can be used in countries other than those specified on theappliance. It is, however, set up for connection to the gas and electricity

Page 13

The control is used to ignite the burner and to regulate thestrength of the flame.The burners can only be switched on by pressing in theappropriate co

Page 14 - Correct use

ControlsThe control is used to ignite the burner and to regulate thestrength of the flame.ßThe gas supply is turned off& Strongest flame/ Weakest

Page 15

Regulating the flameRegulate the flame so that it does not spread out beyond thesides of the pan. As the outer part of the flame is much hotterthan th

Page 16

Burner Min. pan base diameter in cmSmallMediumLargeWok10101215Max. diameter at top of pan in cmWithout WithCombi insertSmallMediumLargeWok22222426---3

Page 17

Wok ringThe Wok ring supplied with your appliance can be used ininstances where extra stability is required. It is particularlysuitable for Woks with

Page 18 - Caring for the environment

–Use a pan lid whenever possible to minimise heat loss.–Cook with as little water as possible.–Cooking times are greatly reduced when using a pressure

Page 19 - Cleaning for the first time

Thermo-electric ignition safety deviceThis appliance is has a thermo-electric ignition safety devicewhich cuts off the supply of gas to a burner if th

Page 20 - Operation

,Do not use a steam cleaning appliance to clean thisappliance. The steam could reach electrical componentsand cause a short circuit.–The appliance sho

Page 21

Cleaning NotesStainless steelsurfacesClean stainless steel surfaces using an E-Cloth(see "Optional accessories") or with a solutionof warm w

Page 22

To assemble the small, medium and large burners^ Place the burner head b on to the burner base e so thatthe ignition safety device d and the ignitor c

Page 23

Gas-heated appliancesSafety precautions to take if you smell gasß Turn off the gas emergency control valve immediately.This is usually located near th

Page 24

To assemble the wok burner^ Place burner head c onto burner base d so that theignition safety device e and the ignitor f extend throughtheir respectiv

Page 25 - Energy saving tips

With the help of the following notes, minor faults in the performance of theappliance, some of which may result from incorrect operation can be put ri

Page 26 - Safety features

Problem Possible cause RemedyThe gas flame goes outafter ignitionThe flames are nottouching the ignitionsafety device, it is nothot enough:- The burne

Page 27 - Cleaning and care

Miele offer a comprehensive range of useful accessories aswell as cleaning and conditioning products for your Mieleappliances.These can be ordered onl

Page 28

Fit the wall units and extractor hoodbefore fitting the appliance to avoiddamaging the surface.~The room in which the gas hob isinstalled must be at l

Page 29

Safety distance above the hobA minimum safety distance must bemaintained between the hob and thecooker hood above it. See the cookerhood manufacturer&

Page 30

Safety distances to the sides andback of the hobIdeally the hob should be installed withplenty of space on either side. Theremay be a wall at the rear

Page 31 - Problem solving guide

Building-in dimensionsKM 2312a Frontb Casing depthc Gas connection R 1/2 - ISO 7-1 (DIN 10226)d Mains connection box with mains connection cable, L =

Page 32

KM 2334a Frontb Casing depthc Gas connection R 1/2 - ISO 7-1 (DIN 10226)d Mains connection box with mains connection cable, L = 2000 mmHobs with frame

Page 33 - Optional accessories

Installation^Make the worktop cut-out as shownin "Building-in dimensions".Remember to maintain the minimumsafety distances (see "Safety

Page 34

Guide to the appliance ...6KM 2312...6KM 2334 / KM 23

Page 35

Seal between appliance andworktopThe sealing strip under the edge of thetop part of the appliance provides asufficient seal for the worktop.The applia

Page 36

Building-in dimensionsKM 2335a Frontb Casing depthc Gas connectionR 1/2 - ISO 7-1 (DIN EN 10226)d Mains connection box with mainsconnection cable, L =

Page 37 - Hobs with frame

Flush fit gas hobs are only suitable for installation ingranite, marble, tiled or solid wood worktops. When usinga worktop made from any other materia

Page 38

InstallationGranite and marble worktopsa Worktopb Hobc GapAs the ceramic glass and theworktop cut-out have a certaindimensional tolerance, the size of

Page 39

Solid wood and tiled worktopsa Worktopb Hobc Gapd Wooden frame 7 mm(to be provided on site)As the ceramic glass and theworktop cut-out have a certaind

Page 40

Building into a stainless steel worktopThis appliance can be welded into a stainless steel worktop. It is essential thatafter being welded, it is stil

Page 41 - Flush fit hob

Secure the appliance as shown, usingthe fixings supplied.20 mm worktop30 mm worktop40 mm worktopAfter installationCheck that all the burners are opera

Page 42

All electrical work should be carriedout by a suitably qualified andcompetent person, in strictaccordance with current local andnational safety regula

Page 43

ImportantThe electrical safety of this appliancecan only be guaranteed if correctlyearthed. It is most important that thisbasic safety requirement is

Page 44

,Connection to the gas supply, orconversion from one type of gas toanother, should only be undertakenby an approved and registered gasinstaller in str

Page 45

Conversion to another type of gas...52Jet table ...52To change t

Page 46 - Securing the appliance

ConnectionThe gas connection must be installedso that connection can be made eitherfrom inside or outside the kitchen unit,and the isolating valve mus

Page 47 - Electrical connection

Nominal ratingKM 2312Burner Gas type High setting Low settingkW g/h kWSmall burner Natural gas HLiquid gas1.01.0-730.250.25Large burner Natural gas HL

Page 48

,Connection to the gas supply, or conversion from onetype of gas to another, should only be undertaken by anapproved and registered gas installer in s

Page 49 - Gas connection

Changing the jetsDisconnect the gas hob from themains electricity supply. Turn off thegas supply.To change the main jetsSmall, medium and large burner

Page 50

Wok burner^ Remove burner cap ab and burnerhead c.^Using an M7 socket spanner,unscrew the main jet d^Fit the correct jets securely (see jettable).^Fin

Page 51 - Burner ratings

To change the small jetsTo change the small jets, the burner securing screws mustfirst be loosened and the upper section of the applianceremoved.^Pull

Page 52 - Jet table

Function testCheck all gas fittings for leaks.^Reassemble the appliance.^Check the burner flame by operating the burner.The flame must not go out on t

Page 53 - To change the main jets

In the event of any faults which you cannot remedy yourself, please contact:–your Miele dealer, or–Miele (see back of manual for contact details).Plea

Page 55 - To change the small jets

598QLWHG.LQJGRP-IELE#O,TD&AIRACRES-ARCHAM2OAD!BINGDON/XON/8474EL#USTOMER#ONTACT#ENTRE4EL%MAILI

Page 56 - Function test

KM 2312a Wok burnerb Large burnerc Small burnerd Pan support (two-part)Controls:e Leftf Back rightg Front rightGuide to the appliance6

Page 57 - Guarantee

M.-Nr. 09 697 380 / 02en-GBKM 2312 / KM 2334 / KM 2335

Page 58

KM 2334 / KM 2335a Small burnerb Medium burnerc Wok burnerd Medium burnere Medium burnerf Pan support (in three sections)Controls:g Front lefth Back l

Page 59

BurnerWok burnera Outer burner capb Inner burner capc Burner headd Burner basee Ignition safety devicef IgnitorSmall, medium and large burnersa Burner

Page 60 - KM 2312 / KM 2334 / KM 2335

Accessories suppliedThe accessories supplied with your appliance as well as arange of optional ones are available to order from Miele (see"Option

Commentaires sur ces manuels

Pas de commentaire