Miele KM 404 Manuel d'utilisateur

Installation InstructionsGas CooktopKM 404KM 406To prevent accidents andmachine damage,read these instructionsbefore installation or use.UVM.-Nr. 05 0

Securing the support barsWood or Corian countertops^ Arrange the bars, b, as shown in theillustration.^ Drill1/16" (1.5 mm) pilot holes throughth

Any pipe connections must be madeusing a thread sealant approved forgas connections. Failure to correctlyinstall these items could lead to agas leak a

ImportantThe cooktop must not bepermanently sealed into thecountertop when installed.The sealing strip under the edge ofthe cooktop provides a suffici

This appliance must be electricallygrounded according to local ornational codes.All electrical work should beperformed by a qualified electricianin ac

Installation and service must beperformed by a qualified installer,service agency or the gas supplier.In Massachusetts a licensedplumber/gas fitter is

Gas pressure regulatorA pressure regulator that is convertiblefrom natural to LP gas (Propane) or viceversa is included with the appliance.The include

Nominal ratingsKM 404Front burner BTU/hr kWMaximum output 6000 1.75Minimum output 1000 0.29Rear burnerMaximum output 10000 2.93Minimum output 1600 0.4

The cooktop should have been orderedfor connection to either natural gas orLP gas (propane).If the cooktop is not configured for theproper type of gas

18

19

2WARNING:If the information in this manual is not followedexactly, a fire or explosion may result causingproperty damage, personal injury or death.–Do

Alterations rights reserved / 4606M.-Nr. 05 060 881 / 06en - USA

IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4Cooktop dimensions . . . . . . . . . . . . . . . . . .

InstallationThe minimum distances given inthese Installation instructions are tocombustible surfaces, and must beobserved to ensure safe operation.Fai

The cooktop must not be installedover a dishwasher, washer, dryer,refrigerator or freezer. Heat radiated bythe cooktop may damage theappliances.Deep f

KM 404a Support bracketsb Building in height plus1/8" (3 mm) forthe fixing screws* Please allow an additional 31/2"(90 mm) depth across the

KM 406a Support bracketb Building in height plus1/8" (3 mm) forthe fixing screws* Please allow an additional 31/2"(90 mm) depth across the r

All Miele combisets have the samelength and width. Make sure that thereis enough room under the countertop toallow for the depth of the variousapplian

Laying out the support barsand bracketsa Support bracketsb Support barsc Slight gap between support bar andcountertopd Bracket center lineThe illustra