Miele CS 1012-1 Manuel de service télécharger pdf (Page 30)

When installing two or more appliances next to each other a spacer bar b must

be used between each one.

See "Fitting the spacer bars and support brackets".

Worktop cut-out

- two appliances

When installing two appliances, the

width of the cut-out required D is

calculated by adding dimensions A and

Worktop cut-out

- three appliances

When installing three appliances the

width of the cut-out required (D) is

calculated by adding dimensions A, B

and C.

A = appliance width (288 mm or 380 mm or 576 mm) less 8 mm

B = appliance width (288 mm or 380 mm or 576 mm)

C = appliance width (288 mm or 380 mm or 576 mm) less 8 mm

D = width of worktop cut-out

When installing more than three

appliances for each additional

appliance add the relevant appliance

width (288 mm or 380 mm or

576 mm) to dimensions A, B and C.

Installation of several appliances

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Pas de commentaire

Miele CS 1012-1 Manuel de service Page 30