Miele KFN 8997 SE ed Instructions d'exploitation télécharger pdf (Page 19)

= 5 is the default setting for the

StayFresh zone. If a setting of

= 1 to

= 4 is selected, the temperature can

fall below 0°C. Food could freeze!

^

Press the Super freeze button to save

the setting.

^

Press the freezer section On/Off

button to come out of the setting

mode.

The electronics will then switch over to

normal operation after a couple of

minutes.

Temperature displays

During normal operation the

temperature display shows the

temperature in the middle of the

refrigerator section and the temperature

in the warmest part of the freezer

section.

If the temperature in the appliance is

not within the range that the appliance

is able to display (above 0 °C in the

refrigerator section and below 0 °C in

the freezer section), bars will flash in

the temperature displays.

The temperature displays flash, if

–

a different temperature is being set,

–

the temperature in the appliance has

risen by several degrees, indicating

that the appliance is warming up too

much.

This loss of coldness is no cause for

concern in the following circumstances:

–

if the door has been left open for a

while, e.g. for removing or storing a

large amount of food,

–

when fresh food is being frozen.

However, if the temperature in the

freezer section remains above -18 °C

for a long time, check that the frozen

food has not started to defrost. If it has

started thawing, check that the food is

safe to use and if it is, use it as quickly

as possible.

Temperature display brightness

The appliance is supplied with the

brightness of the temperature display

set as low as possible. However, if the

door is opened, a setting changed or if

the alarm is sounding, the temperature

display will appear much brighter for

approx. 1 minute.

You can adjust the level of brightness:

^

Press and hold the Super freeze

button for approx. 5 seconds.

The Super freeze indicator light flashes

and a

; flashes in the temperature

display.

^

Press one of the temperature selector

buttons repeatedly until an

^ appears

in the display.

The correct temperature

19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Commentaires sur ces manuels

Pas de commentaire