Miele PT 7135 C Manuel de service télécharger pdf (Page 60)

4 Service

4.1 Programming mode summary

PT 7135 C, PT 7136

Initial requirements

A Finish or cancel any programme in operation, including the demonstration

mode.

A Open the door.

A Disconnect the fill ring NTC temperature sensor (1R30) plug.

Note

If the fill ring NTC temperature sensor (1R30) plug is disconnected at the power-

programme module (1N1), then power is also no longer supplied to the door lock

(A2). In this case the programming mode cannot be accessed.

A If the international multilingual start screen is shown, select the desired

language.

Accessing

Note

After it is begun, the accessing procedure must be completed within 10 s.

A Press and hold the Start button.

A Close the door.

A As soon as the Start button flashes, release the Start button.

A Immediately press and release the Start button 5 times and at the 5th time

hold it pressed in until programmable functions are shown in the display.

Acknowledgement indicator

Successful accessing of the programming mode is indicated by rapid flashing

(5 Hz) of the Start button.

The display shows the Service Dept. programmable functions.

If the accessing procedure has been unsuccessful, the control automatically

reverts to the normal operating mode.

Descriptive Technical Documentation

080-24 DTD no. 521-7135

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 87 88

Pas de commentaire

Miele PT 7135 C Manuel de service Page 60